Horizontal Moving Boiler Chain Grate Grate Cooler In Cement Plant Assembled Installation

Top Quality Factory price Chain Grate Heating Boiler reciprocate grate

Its characteristics are:

1. The combustion air is sent from the bottom of the furnace and blown out from the gap of the grate block (different grate technologies make the gap position different, generally located in the front of the grate block), which has a good cooling effect on the grate.

2. When the grate is pushed, including the fixed grate, it can achieve relative movement around, each grate has about 20mm of staggered action, which can make some low melting point (lead, aluminum, plastic, rubber, etc.) material bonded on the vent of the grate blow away, and maintain good ventilation conditions.

3. As the reverse pushing can extend the residence time of garbage in the furnace correspondingly, the area of the grate can usually be less than that of the pushing grate with the same processing capacity.

MARTIN is the typical representative of this kind of grate technology.

Advantages:

1. The height of the horizontal reciprocating grate is lower than that of the inclined reciprocating grate, which can effectively save the area of ​​the boiler room, thereby reducing the installation and use cost of the user.

2. In the horizontal reciprocating grate, through the operation of the equipment, the fuel layer (coal layer) can be uniformly covered on the grate, and at the same time, compared with the conventional grate, the internal connection of the grate is relatively tight, and there is no air leakage. The area, so that the wind speed through the coal seam is relatively uniform, the content of coal ash after combustion is significantly reduced.

3. The coal seam is wave-shaped on the horizontal reciprocating grate, and its surface area is 30% to 50% larger than the horizontal surface area of ​​the grate. Therefore, the flow rate of the flue gas leaving the surface of the coal seam is relatively slow, so that the amount of fly ash is reduced compared with the chain grate. 10%.

4. The combustion efficiency of the fuel in the horizontal reciprocating grate is relatively high. Therefore, the furnace temperature is high and the combustion is relatively sufficient, so that coals with strong coking properties can be burned. It can also burn cohesive biomass fuel, which greatly improves the adaptability of the grate to fuel.

5. The fuel preparation and dust removal equipment is simple, the overall cost, low operating cost and simple operation management.
Data sheet of reciprocating grate stoker